Revamp of bridging code.

- Use sysfs to read bridge information from the system instead of
  parsing the brctl outputs.
- Allow setting of all bridge configuration parameters using new sysfs
  methods, modelled after bonding configuration. Also works for per-port
  bridge interface parameters.
- Document pre-starting an empty bridge for dynamic add.
- Check for interface existence before adding to bridge.
- Should fix bug #293046, #309185.

1 files changed, 12 insertions, 0 deletions

diff --git a/doc/net.example.Linux.in b/doc/net.example.Linux.in
index 4ebe1a7..582c161 100644
--- a/doc/net.example.Linux.in
+++ b/doc/net.example.Linux.in
@@ -805,6 +805,18 @@
 #sethello 0
 #stp off"
 
+# You can also configure the bridge or bridge members via sysfs on 2.6 kernels
+# or newer. See the kernel bridge documentation for a description of these
+# options.
+#stp_state_br0="0"
+#forward_delay_br0="10"
+#hairpin_mode_eth0="1"
+
+# If you want to start an empty bridge, and then dynmically add ports to it you
+# MUST set the following variables (with the correct interface name).
+# If you get the error "Misconfigured static bridge detected", this means you.
+#bridge_br0=''
+
 #-----------------------------------------------------------------------------
 # RFC 2684 Bridge Support 
 # For RFC 2684 bridge support emerge net-misc/br2684ctl