# ifconfig under Linux is not that powerful and doesn't easily handle # multiple addresses # On the other hand, ip (iproute2) is quite powerful and is also supported # ip_eth0="192.168.0.10/24; 192.168.10.10/24" # Create a bonded interface # interfaces="bond0" # ifup_bond0="modprobe bonding; ifconfig \$int up; ifenslave \$int bge0" # ifconfig_bond0="192.168.0.10 netmask 255.255.255.0" # ifdown_bond0="rmmod bonding" # Create a bridged interface - let dhcpcd configure the address # interfaces="br0" # ifup_br0="brctl addbr \$int; brctl add \$int eth1; brtctl add \$int eth2" # ifdown_br0="ifconfig \$int down; btctl delbr \$int" # Create VLAN # interfaces="eth0_2 eth0_3 eth0_4" # ifup_eth0="vconfig add \$int 2; vconfig add \$int 3; vconfig add \$int 4" # ifconfig_eth0_2="192.168.2.10 netmask 255.255.255.0" # ifconfig_eth0_3="192.168.3.10 netmask 255.255.255.0" # ifconfig_eth0_4="192.168.4.10 netmask 255.255.255.0" # ifdown_eth0="vconfig rem \$int.2; vconfig rem \$int.3; vconfig rem \$int.4" # Normally you would use wpa_supplicant to configure wireless, but you can # use iwconfig also # ifup_wlan0="iwconfig \$int key s:secretkey enc open essid foobar"