# Assign static IP addresses and run custom scripts per interface. # Seperate commands with ; # Prefix with ! to run a shell script. # Use \$int to represent the interface #ifconfig_eth0="192.168.0.10 netmask 255.255.255.0" # You also have ifup_eth0 and ifdown_eth0 to run other commands when # eth0 is started and stopped. # You should note that we don't stop the network at system shutdown by default. # If you really need this, then set shutdown_network=YES # You can assign a default route #defaultroute="192.168.0.1" # Lastly, the interfaces variable pulls in virtual interfaces that cannot # be automatically detected. #interfaces="br0 bond0 vlan0" # You can also use files instead of variables here if you like: # /etc/ifconfig.eth0 is equivalent to ifconfig_eth0 # /etc/ip.eth0 is equivalent to ifconfig_eth0 # /etc/ifup.eth0 is equivalent to ifup_eth0 # /etc/ifdown.eth0 is equivalent to ifdown_eth0 # Any files found will automatically be put into the interfaces variable. # You don't need to escape variables in files, so use $int instead of \$int. # If you require DHCP, you should install dhcpcd and it to the boot or # default runlevel.